Product Printout


    Excitron Corporation

     333 N Snowmass Cir
     Superior, Colorado  USA  80027

 

         303-859-9476

Excitron shipping address is 333 N Snowmass Cir, Superior, CO 80027, and we have large manufacturing facilities in Broomfield and Lafayette, CO.  We offer direct sales from our manufacturing plants and ship worldwide, there are no distributors or reps.  please email.

Excitron Privacy Policy: The contact, credit card or banking, billing and shipping information collected on this site will be only be used to collect payment and deliver Excitron’s products to the online customers. No information will be distributed to third parties, and all information will be kept secure and confidential by Excitron.

 

Product Information

 


 
    

10A-RS232 -- Controller/Driver, 10 amps, w/RS232



Now Only
US $229.00



Product Information
 
 
Item Details
 
Controller/driver only (without motors) with built-in RS232 serial interface. No other RS232 adaptor needed.

This Controller is replaced by the newer Au Controllers, this Controller is intended only for replacements. Unit comes with a 5 pin header for connecting to a unipolar stepper motor that has a 5 pin Molex or Amp .100" pitch housing. Select this controller to drive unipolar stepper motors that are size 23 (57mm) or smaller. The 10A-RS232 can drive up to 10 amps burst, 3 normally. These controllers are microminiature and exceptionally small.

For Controller drawing and details, see 3.45_Controller_Manual.pdf for DB15 type Controllers, in the Documentation link on home page lower left for and details. This 10A-RS232 has a different pinout than the DB15 Controller, otherwise all commands are the same. These controllers run "right out of the box" by typing a 'w' then 'G'. Each Excitron controller includes all the electronics and drivers for running the stepper motor. There are no separate electronic boxes and no messy cables. Included here is a full range of details of our motor/controller family.

You easily control how your stepper motor operates in these modes:

  • Serial Command Mode: send and receive via RS232,.Connection with PCs, PLCs or Labview work well.
  • Standalone Motion Profile Mode: repeatedly run a sequence of motion profiles, exactly as you wish, upon powerup. In this case, your computer is not needed. You can use inputs to control how and when these profiles run.
  • Input Profile Mode: each of up to 3 input pins trigger 3 motion profiles each, giving you random selection of motion by simply pushing buttons.

You can combine many of these modes, with few restrictions. Hundreds of successful customers have created very ingenious motion using these simple "building blocks", some in as little as 10 minutes.

You can easily setup the Excitron controller for standalone (Motion Profile) mode so that it performs exactly as you wish upon powerup. In this case, your computer is not needed. The Excitron controller has many useful modes for inputs and for the one output, so that you can add intelligent repetitive motion to almost any device. Connection with PLCs or Labview work well.